- Werkstoff
- Nominale Teilenummer
- 35
- Abstand Befestigungsbohrung - Führungswagen (Breitrichtung)(mm)
- 50
- Abstand Befestigungsbohrung - Führungswagen (Längsrichtung)(mm)
- 50
- Durchmesser Befestigungsbohrung - Führungswagen
- 8
- Abstand Befestigungsbohrung - Schiene(mm)
- 80
- Durchmesser Befestigungsbohrung - Schiene
- 9
- Das Führungswagen-Außenmaß W(mm)
- 70
- Das Führungswagen-Außenmaß L(mm)
- 109.4
- Befestigungsbohrung für Führungswagen
- Montagebohrung, Maß S(M)
- Montagebohrung, Einschraubtiefe(mm)
- 12
- Führungswagen-Maß L1(mm)
- 80.4
- Symbole für Widerstandsfähigkeit gegen Staub
- Ausführung
- CAD
- 2D
- 3D
- Vsl. Versanddatum
- Alle
- Innerhalb von 5 Werktagen
Führungswagen für Profilschienen / HSR / Material wählbar / Kugelumlauf / großer Wagen, Wagendimensionen wählbar (HSR35R1SS(GK))
Weitere Informationen
Grundlegende Informationen
An individual block from the THK LM guide HSR series. Extremely useful for sudden design changes and when performing maintenance.
[Features]
· Circulates the ball row using the end plate that is assembled in the LM block when the ball rotates the rotating side with four rows that have been precision ground into the LM block and LM rail.
· The ball will not fall out even if the LM rail is removed because it is held by a holding plate. (Excludes the HSR8,10, and 12).
· Each of the rail rows has been positioned at a 45° contact angle so that the rated load will be the same for all four directions (radial direction, reverse radial direction, horizontal direction) that act on the LM block, which allows it to be used in any position, and is also stable due to incurring a preload with a good balance, and makes it possible to maintain a constant low friction coefficient, and increase rigidity in four directions. Has a low cross-section height, and the LM block has been designed with a high rigidity, which allows for highly precise and consistent linear motion.